3. Write a function simulating a calculator on two integer numbers. The function is going to receive a character “op” representing an operation (+,-,*,/,%,etc), “num1” and “num2”. The function is going to check that the input is valid.
If the input is not valid, the function is going to print a corresponding message to the screen and return 0. Otherwise, if the input is valid, then the function should return the result of the operation. For example:
- for op ‘+’ the function is going to return “num1+num2”.
- for op ‘-‘ the function is going to return “num1-num2”.

c++

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

1. the program must provide following functions to extract some statistics. note that the data_list parameter specified in these functions may be the same for all functions or different for different functions—that is your choice. a skeleton file is provided on mirmir. a) open_file()prompts the user to enter a year number for the data file. the program will check whether the year is between 1990 and 2015 (both inclusive). if year number is valid, the program will try to open data file with file name ‘year.txt’, where is the year. appropriate error message should be shown if the data file cannot be opened or if the year number is invalid. this function will loop until it receives proper input and successfully opens the file. it returns a file pointer and year. i. hint: use string concatenation to construct the file name b) read_file(fp)has one parameter, a file pointer read. this function returns a list of your choosing containing data you need for other parts of this project. c) find_average(data_list) takes a list of data (of some organization of your choosing) and returns the average salary. the function does not print anything. hints: i. this is not the average of the last column of data. it is not mathematically valid to find an average by finding the average of averages—for example, in this case there are many more in the lowest category than in the highest category. ii. how many wage earners are considered in finding the average (denominator)

Q-1 which of the following can exist as cloud-based it resources? a. physical serverb. virtual serverc. software programd. network device