Speed adjustment on the highway are necessary because of what three factors

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?

Asequential circuit contains a register of four flip-flops. initially a binary number n (0000 ≤ n ≤ 1100) is stored in the flip-flops. after a single clock pulse is applied to the circuit, the register should contain n + 0011. in other words, the function of the sequential circuit is to add 3 to the contents of a 4-bit register. design and implement this circuit using j-k flip-flops.