Engineering, 06.07.2019 04:10 idjfjcjs584

Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg. k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. th...

Questions