Engineering, 11.07.2019 01:30 davidsouth444

An ideal rankine cycle with reheat uses water as the working fluid. the conditions at the inlet to the high-pressure turbine are 10mpa, 650°c and the steam is reheated at a constant pressure o f 1.4mpa before entering the low-pressure turbine. for a condenser pressure of 10kpa, plot the cycle thermal efficiency and quality of steam at the low- exit versus reheat temperatures (the temp of steam entering the low pressure turbine) of 300, 400, 500, and 600°c (15 points). draw the t-s diagram and show all your work for a reheat temperature of 300°c. note: : there will be two plots. one with thermal efficiency on in the ordinate versus reheat temperate and the other will have quality on the ordinate versus reheat temperature .be sure to label all axes with variables and units and include title. the plots must be done on computer,

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

An ideal rankine cycle with reheat uses water as the working fluid. the conditions at the inlet to t...

Questions