Engineering, 11.07.2019 03:20 125712
The most common type of rigid coupling is a) ribbed coupling b) sleeve coupling c) flange coupling d) grid coupling
Answers: 3
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
The most common type of rigid coupling is a) ribbed coupling b) sleeve coupling c) flange coupling d...
English, 07.07.2019 23:30
Arts, 07.07.2019 23:30
Business, 07.07.2019 23:30
Chemistry, 07.07.2019 23:30
Mathematics, 07.07.2019 23:30
Mathematics, 07.07.2019 23:30
History, 07.07.2019 23:30
Health, 07.07.2019 23:30