Engineering, 15.07.2019 09:10 Jessicawilliams3569

16. valve timing in most engines is such that (a) the intake valve opens before the
piston reaches top dead center-tdc-and closes after the piston reaches bottom
dead center-bdc (b) the exhaust valve opens before the piston reaches bdc and
closes after the piston reaches tdc (c) both valves are partially open at the same
time. (d) all of these.
17. which of the following is placed between the engine block and the cylinder head? (a) timing gear cover (b) an oil seal (c) a gasket (d) an oil pan.
18. a one cylinder engine with one valve in the head and one valve in the block is an
(a) l-head engine (b) t-head engine (c) f-head engine (d) i-head engine.
19. a supercharger is typically used with a (a) miller-cycle engine
(b) variable compression engine (c) two-stroke cycle diesel engine (d) all of these.
20. regenerative braking is most commonly found on (a) hybrid vehicles
(b) two stroke diesel engine vehicles (c) rotary engine vehicles
(d) natural gas vehicles.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

16. valve timing in most engines is such that (a) the intake valve opens before the
piston reac...

Questions