Engineering, 17.07.2019 21:10 garacey241
Ahollow circular column of external diameter 200 mm and thickness 5 mm is 6 m long. for the material properties of the column, a column is considered short if the slenderness ratio is less than or equal to 70 a yield stress of 280 mpa to a proportional limit of 210 mpa may be used. find the load capacity of the column.
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180Β°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in Β°r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Ahollow circular column of external diameter 200 mm and thickness 5 mm is 6 m long. for the material...
Biology, 09.07.2019 06:30
English, 09.07.2019 06:30
Geography, 09.07.2019 06:30
History, 09.07.2019 06:30
English, 09.07.2019 06:30
Mathematics, 09.07.2019 06:30
Mathematics, 09.07.2019 06:30
Biology, 09.07.2019 06:30
Biology, 09.07.2019 06:30
Advanced Placement (AP), 09.07.2019 06:30