subject
Engineering, 17.07.2019 22:20 gonzalesrosalinda66

Arefrigerator operating on the vapor-compression refrigeration cycle using refrige the refrigerant is considered. the temperature of the cooled space and the ambient a 13°c and 27°c, and leaves at 1 mpa and 70°c. the refrigerant leaves the condenser as saturated liquid. the rate of cooling provided by the system is 13 kw determine ir are at respectively. r-134a enters the compressor at 140 kpa as a saturated vapour a) the mass flow rate of r-134a and the cop b) the exergy destruction in each component of the cycle and the second law eficingy of the compressor, and c) the second law efficiency of the cycle and the total exergy destruction in the cycle

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Arefrigerator operating on the vapor-compression refrigeration cycle using refrige the refrigerant i...
Questions
question
Spanish, 27.05.2021 03:10
question
Mathematics, 27.05.2021 03:10
question
Health, 27.05.2021 03:10
question
Mathematics, 27.05.2021 03:10
question
Social Studies, 27.05.2021 03:10
question
Health, 27.05.2021 03:10
Questions on the website: 13722361