Engineering, 26.07.2019 16:10 nooope

Atransformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10 cm x 6.2 cm wide gold heat sink to its top surface. the heat sink has seven fins, which are 5 mm high, 2 mm thick, and 10 cm long. a fan blows air at 25°c with a velocity of 6 m/s parallel to the passages between the fins. the heat sink is to dissipate 12 w of heat and the base temperature of the heat sink is not to exceed 45°c to maintain safe operation. is this design enough to cool the transformer to safe levels?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

Atransformer that is 10 cm long, 6.2 cm wide, and 5 cm high is to be cooled by attaching a 10 cm x 6...

Questions