Engineering, 26.07.2019 16:10 crodriguez87
During a cooling process with dehumidification, where does the hot and humid air dehumidify? a)-on the cooling coils b)-on the walls of air ducts c)-on a special dehumidifying device on a d)-in the mixing chamber
Answers: 3
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
During a cooling process with dehumidification, where does the hot and humid air dehumidify? a)-on...
Mathematics, 17.02.2021 02:50
Social Studies, 17.02.2021 02:50
Chemistry, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
English, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
Mathematics, 17.02.2021 02:50
Business, 17.02.2021 02:50