Engineering, 26.07.2019 17:30 Frostbite9371

Athick casting initially at a uniform temperature of 150 c has properties of ρ=2790 kg/m3, k- 1.6 w/m-k and cp=956 j/kg-k. the surface of the casting is suddenly exposed to turbulent water at 20 c, giving a very large convective heat transfer coefficient a) using an explicit finite-difference scheme with 5x-6mm, determine the length of time required for the temperature 18 mm beneath the surface to change from its initial value. b) based on the results of your finite-difference solution, determine an approximate value for the heat (q") being convected from the surface after 1.5 minutes. c) sketch a plot of surface heat flux, q", as a function of time. the time obtained in part a of part a for the temperature 18 mm from the surface d) using to change from its initial value, check the temperature at that location (x=18 mm) using a different method.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Athick casting initially at a uniform temperature of 150 c has properties of ρ=2790 kg/m3, k- 1.6 w/...

Questions