Engineering, 26.07.2019 19:20 WallaceHarrison123

Amultiple disk clutch, steel on bronze, is to transmit 5 hp at 750 rpm. the inner radius of contact is 1.5 in and the outer radius of contact is 2.75 in. the clutch operates in oil with an expected coefficient of friction 0.10. (oil is used to give smoother engagement, better dissipation of heat, even though the capacity is reduced.) the average allowable pressure. is 50 psi, maximum. (how design pressures are used to provide for sufficient size to give yood heat dissipation capacity.) assuming uniform wear, determine the following: a) how many total dishes of sted and bronze are required? b) what axial force is required? c) what is the average pressure?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

You know the right answer?

Amultiple disk clutch, steel on bronze, is to transmit 5 hp at 750 rpm. the inner radius of contact...

Questions