Engineering, 26.07.2019 20:20 taylorb9893
When do you want to use shell feature? a)-make a 2d sketch of a gear b)-make a 3d model of a gear box c) make a 2d shell of a shaft (d) make a 3d mate for a cam
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:20
Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?
Answers: 3
You know the right answer?
When do you want to use shell feature? a)-make a 2d sketch of a gear b)-make a 3d model of a gear b...
Questions
Physics, 18.11.2019 19:31
History, 18.11.2019 19:31
Computers and Technology, 18.11.2019 19:31
Mathematics, 18.11.2019 19:31
