subject
Engineering, 05.08.2019 17:20 tdahna0403

Aheated long cylindrical rod is placed in a cross flow of air at 20°c (1 atm) with velocity of 10 m/s. the rod has a diameter of 5 mm and its surface has an emissivity of 0.95. if the surrounding temperature is 20°c and the heat flux dissipated from the rod is 15700 w/m2, determine the surface temperature of the rod. evaluate the air properties at 70°c. the properties of air (1 atm) at 70°c are k = 0.02881 w/m∙k, v = 1.995 × 10^−5 m2/s, and pr = 0.7177.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
Aheated long cylindrical rod is placed in a cross flow of air at 20°c (1 atm) with velocity of 10 m/...
Questions
question
Mathematics, 30.01.2020 09:53
Questions on the website: 13722362