Engineering, 06.08.2019 18:10 leelee8335

Atube-in-tube heat exchanger is used to cool engine oil by transforming heat to a flow of 40% ethylene glycol-water solution. the engine oil enters the heat exchanger at th, in= 85°c and flow through the annular space that is formed between the inner and outer tubes while the ethylene glycol flows through the inner tube. the total length of the heat exchanger is l = 12.1 m and the inner tube made of 304 stainless steel with outer diameter do = 1.0 cm and the wall thickness of 1.1 mm. the heat transfer coefficient between the engine oil and the inner tube surface is 350 w/m2-k. the ethylene glycol enters the heat exchanger at tc, in= 22°c and flows through the center tube in a counter-flow configuration with a mass flow rate of 0.012 kg/s. the fouling factor associated with the flow of the engine oil is 0.000179 k-m2/w and the fouling factor associated with the ethylene glycol is 0.00043 k-m2/w. determine the conductance (ua) of the heat exchanger

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

You know the right answer?

Atube-in-tube heat exchanger is used to cool engine oil by transforming heat to a flow of 40% ethyle...

Questions