subject
Engineering, 07.08.2019 17:20 mjmckay03

Steam at a temp. of 500 degrees celsius and pressure of 20mpa enters a rankine cycle and expands adiabatically to a condenser pressure of 100kpa. the adiabatic pump consumes 35 kj/kg of energy to bring the pressure of the liquid saturated water (x = 0) that is exiting the condenser up to the pressure of the boiler. the thermal efficiency of the power plant is 0.40. 1. draw a t-s diagram that shows 1 complete cycle of this power plant. 2. draw the power plant with its compartments and label them. 3. how much heat (in kj/kg) is put into the cycle during the heat absorption process? d) what is the isentropic efficiency of the turbine? (ignore changes in potential or kinetic energy). e) what is the isentropic efficiency of the pump?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 18:20
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Steam at a temp. of 500 degrees celsius and pressure of 20mpa enters a rankine cycle and expands adi...
Questions
question
Mathematics, 18.07.2019 21:10
question
Mathematics, 18.07.2019 21:10
Questions on the website: 13722361