Engineering, 07.08.2019 18:10 reyrey216
Aplate is to be bent to 90° by pressing between two dies that have concave and convex 90° bends. once the operation is completed and the part is removed, is the angle of bend going to be more than or less than 90°? why?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
Aplate is to be bent to 90° by pressing between two dies that have concave and convex 90° bends. onc...
Questions
Computers and Technology, 03.12.2021 22:30
Physics, 03.12.2021 22:30
Computers and Technology, 03.12.2021 22:30
Social Studies, 03.12.2021 22:30
Computers and Technology, 03.12.2021 22:30
Business, 03.12.2021 22:30
English, 03.12.2021 22:30
Mathematics, 03.12.2021 22:30
