Engineering, 07.08.2019 19:10 Jasmineemarieee

It is often necessary to prepare a gas mixture with accurately known composition. such mixtures are used to calibrate gas analysis instruments. in the present case, a mixture of 80% ethylene (molar basis) (c2h4) and 20% carbon dioxide (co2) is prepared in the following manner. two un-insulated tanks, each of 4 liter volume, are connected together. one tank contains ethylene gas at 100 atm, 25 c. the other contains carbon dioxide at 25 c and pco2,1. the valve connecting the tanks is now opened and remains open for a long time until a homogeneous mixture at the desired proportions is obtained. the surroundings are at 25*c, 1 atm. answer the following questions assuming that the gas mixture obeys the ideal gas law. a. what is the initial co2 pressure, pco2,1? b. what is the final pressure of the gas mixture? c. what is the heat transfer for this process? d. what is the total entropy generation for this process?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

You know the right answer?

It is often necessary to prepare a gas mixture with accurately known composition. such mixtures are...

Questions