subject
Engineering, 07.08.2019 19:20 TerronRice

A50-mm-diameter, thin-walled metal pipe covered with a 25-mm-thick layer of insulation (0.085 w/m k) and carrying superheated steam at atmospheric pressure is suspended from the ceiling of a large room. the steam temperature entering the pipe is 120°c, and the air temperature in the room is 20°c. the convection heat transfer coefficient on the outer surface of the covered pipe is 10 w/m2 k. the velocity of the steam in the pipe is 10 m/s. the steam temperature at the outlet of the pipe is at tmo =106°c 1. calculate the mass flow rate of steam in the pipe. 2 calculate the total ua for the entire pipe 3 calculate the internal heat transfer coefficient hi 4 construct a resistance model and calculate the resistances “r” that affect the heat transfer from the steam to the outside air. 5 calculate the length of the pipe. 6 calculate the temperature of the pipe's surface at the exit of the pipe (tso) using the resistance model at the outlet of the pipe. 7 what would happen if tmo was cooler than 106°c?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
You know the right answer?
A50-mm-diameter, thin-walled metal pipe covered with a 25-mm-thick layer of insulation (0.085 w/m k)...
Questions
question
Mathematics, 21.01.2021 22:30
question
Biology, 21.01.2021 22:30
question
Computers and Technology, 21.01.2021 22:30
Questions on the website: 13722363