Engineering, 20.08.2019 17:20 keaisad12
A150 mm outer diameter by 110 mm inner diameter steel hub with 280 mm assembled on a 110 mm diameter steel shaft with a heavy press-fit.. the modulus of elasticity is to be 200gpa with a maximum clearance of 0.085mm. determine the following i) the pressure at the contact surface ii the tangential stress ii) the axial force for the system iv) the torque transmitted by the system
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
You know the right answer?
A150 mm outer diameter by 110 mm inner diameter steel hub with 280 mm assembled on a 110 mm diameter...
Questions
History, 22.11.2019 21:31
Chemistry, 22.11.2019 21:31
Biology, 22.11.2019 21:31
History, 22.11.2019 21:31
