Engineering, 21.08.2019 02:30 ryleeyeagley03
It is known that heat checking occurs when grinding with a spindle speed of 6000 rpm, a wheel diameter of 250 mm, and a depth of cut of 0.0375 mm for a feed rate of 0.25 m/s. for this reason, the spindle speed should be kept at 4500 rpm. if a new, 200-mm- diameter wheel is used, what spindle speed can be employed before heat checking occurs? what spindle speed should be used to keep the same grinding temperatures as those encountered with the existing operating conditions?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
It is known that heat checking occurs when grinding with a spindle speed of 6000 rpm, a wheel diamet...
Questions
Biology, 18.03.2020 04:14
Mathematics, 18.03.2020 04:14
English, 18.03.2020 04:14
History, 18.03.2020 04:15
Mathematics, 18.03.2020 04:15
Mathematics, 18.03.2020 04:16
History, 18.03.2020 04:16
