Engineering, 22.08.2019 01:10 kaliyaht01

At the inlet to an axial diffuser the velocity of the approaching air is 420 m/s, the stagnation pressure is 300 kpa, and the stagnation temperature is 600 k. at exit the stagnation pressure is 285 kpa and the static pressure 270 kpa. using compressible flow analysis, determine (i) the static temperature, static pressure, and mach number at inlet and the diffuser efficiency; (ii) the mach number at exit and entry. for air take γ = 1.376 and r = 287 j/(kg k).

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

Answer

You know the right answer?

At the inlet to an axial diffuser the velocity of the approaching air is 420 m/s, the stagnation pre...

Questions