Engineering, 22.08.2019 02:10 dtrammel91
Aplant processes very long tungsten beams with a cross-section of 50-cm by 50-cm in a furnace with air temperature of 900 celsius degree and a convective heat transfer coefficient of 300 w/m^2k. the initial temperature of the beam is 27 celsius degree, and the required process temperature is 650 celsius degree. assume the tungsten properties are evaluated at the average temperature(between initial and process temperatures). the beams are suddenly exposed to furnace conditions. ignore radiation. draw a schematic and label all relevant parameters determine: a)the tungsten thermal properties(thermal conductivity, specific heat, and thermal diffusivity at the average temperature) b)the biot number c)what locations on the beam will first reach the required temperature? d)how much time is needed (in s) to reach the required temperature at the locations found in c) –that first reach required temperature? e)what will be the answer for d) is one assumes lumped heat capacity model?
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
Aplant processes very long tungsten beams with a cross-section of 50-cm by 50-cm in a furnace with a...
Mathematics, 28.11.2019 13:31
Social Studies, 28.11.2019 13:31
History, 28.11.2019 13:31
Computers and Technology, 28.11.2019 13:31
Mathematics, 28.11.2019 13:31
French, 28.11.2019 13:31
History, 28.11.2019 13:31
English, 28.11.2019 13:31
Physics, 28.11.2019 13:31