Engineering, 22.08.2019 16:20 shewag8749
Assume that for the previous problem you obtained values of -10 ksi for the bending stress at a and -2.0 ksi for the shear stress at a (using beam sign conventions; neither of which are the answers to problem 3). for the given state, use the principle stress and max in-plane shear stress to determine the safety factor at this location if the material at the joint at a has a 30 ksi failure strength in compression and a 10 ksi failure strength in shear.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
You know the right answer?
Assume that for the previous problem you obtained values of -10 ksi for the bending stress at a and...
Questions
History, 09.08.2021 20:40
