Engineering, 22.08.2019 16:30 MK100

A2 mx 1.5 m section of wall of a furnace is not insulated and the temperature at the outer surface of this section is measured to be 110 °c. the temperature of the furnace room is 32 °c. it is proposed to insulate this section with glass wool insulation (k = 0.038 w/m. k) in order to reduce the heat loss by 90 percent. determine the thickness of the insulation using the total thermal resistance, assuming the outer surface temperature of the metal section still remains at 110 °c, the effective convection heat transfer coefficient at the surface of the outer furnace is h = 10 w/m²k and disregarding any radiation.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.

Answers: 2

Answer

You know the right answer?

A2 mx 1.5 m section of wall of a furnace is not insulated and the temperature at the outer surface o...

Questions