subject
Engineering, 24.08.2019 03:30 kihgff5711

A78-cm diameter pipeline bends in a semicircular arc of outer radius equal to 2.5 m in the vertical plane. when 0.96 m/s of water flows through the bend with an absolute pressure of 158 kpa at the lower inlet section, what is the force of flow on the bend in the horizontal direction

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
You know the right answer?
A78-cm diameter pipeline bends in a semicircular arc of outer radius equal to 2.5 m in the vertical...
Questions
question
Mathematics, 05.07.2019 17:40
question
Mathematics, 05.07.2019 17:40
question
Chemistry, 05.07.2019 17:40
Questions on the website: 13722367