Engineering, 29.08.2019 18:30 ayoismeisalex

Aeutectic alloy is which of the following (two correct answers): (a) the composition in an alloy system at which the two elements are present in equal proportions, (b) the composition in an alloy system for which the solidus and liquidus are at different temperatures, (c) the composition in an alloy system for which the solidus and liquidus are at the same temperature, (d) the composition in an alloy system that has the highest melting point, and (e) the composition in an alloy system that has the lowest melting point?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

You know the right answer?

Aeutectic alloy is which of the following (two correct answers): (a) the composition in an alloy sy...

Questions