Engineering, 30.08.2019 23:30 AnimePo2020
A70mm 6g shaft is to fit a 70mm 4h hole. determine the maximum and minimum clearances determine the upper and lower dimensions of a go-not-go gauge and ring gauge set to inspect the above hole and shaft
Answers: 2
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
Engineering, 06.07.2019 03:10
Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?
Answers: 2
Engineering, 06.07.2019 03:10
An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.
Answers: 1
Engineering, 06.07.2019 04:10
Cold water (cp=4180j/kg k) leadıng to a shower enters a thin-walled double-pipe heat transfer at 15c at a rate of 0.25kg/s and is heated to 45c by hot water (cp=4190j/kg k) that enters at 100c at the rate of 3kg/s. if the overall heat transfer coefficient is 950w /m2 k , determıne the rate of heat transfer and the heat transfer surface area of the heat exchanger using e - ntu method
Answers: 1
A70mm 6g shaft is to fit a 70mm 4h hole. determine the maximum and minimum clearances determine the...
History, 19.09.2021 14:30
Physics, 19.09.2021 14:40
History, 19.09.2021 14:40
Physics, 19.09.2021 14:40
Social Studies, 19.09.2021 14:40
Biology, 19.09.2021 14:40
Mathematics, 19.09.2021 14:40
Mathematics, 19.09.2021 14:40
Social Studies, 19.09.2021 14:40
English, 19.09.2021 14:40
Mathematics, 19.09.2021 14:40
Mathematics, 19.09.2021 14:40