Engineering, 31.08.2019 05:30 cat20220

An operating theatre is maintained at an inside temperature of 26°c dry-bulb when the outside air is at 40°c dry-bulb, 22°c wet-bulb and the sensible and latent heat gains in the operating theatre are 9 kw and 3 kw, respectively. a 100 per cent fresh air is handled, the air temperature leaving the cooling coil being 14°c and the apparatus dewpoint 12°c. assume a rise of 1.5°c across the supply fan (which is located after the cooling coil) and a further rise of 2°c because of heat gains to the supply duct. show the psychrometric processes on the psychrometric chart and determine (a) the shf (sensible heat factor) in the theatre (b) the wet bulb temperature of the supply air just after the cooling coil (c) the relative humidity of the air maintained in the theatre. (d) mass flow rate of supply air required (e) the cooling load of the cooling coil

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

An operating theatre is maintained at an inside temperature of 26°c dry-bulb when the outside air is...

Questions