subject
Engineering, 03.09.2019 04:20 jeftegerman988

In an air conditioner that cools with r134-a and with a by-pass factor of 0.53, the air enters at 35 (° c) and 70 percent relative humidity at a speed of 5 (m3 / min). the refrigerant (r134a) enters a in the coil at 400kpa with a quality of 20% and leaves as satured vapor. the air at the outlet of the conditioning system can be considered a mixture of air that cools to the temperature of the refrigerant and air that exits in the same conditions as at the inlet. determine: 1. mass flow rate of dry air (kg_a/s).2. air outlet temperature (ºc).3. specific enthalpy (kj / kg_as) and absolute humidity (kg_v / kg_as) of the air at the exit.4. the rate of dehumidification(kg_w / h).5. heat flow rate exchanged between refrigerant and air (kw) .6. mass flow rate of refrigerant (kg / s).7. entropy generated in the refrigerant as a system.8. draw the psychrometric diagram.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
In an air conditioner that cools with r134-a and with a by-pass factor of 0.53, the air enters at 35...
Questions
question
History, 02.02.2021 03:00
question
Mathematics, 02.02.2021 03:00
question
Mathematics, 02.02.2021 03:00
question
Chemistry, 02.02.2021 03:00
question
Computers and Technology, 02.02.2021 03:00
question
Chemistry, 02.02.2021 03:00
question
Chemistry, 02.02.2021 03:00
Questions on the website: 13722360