subject
Engineering, 10.09.2019 18:30 elielson1497

The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum depth of around 11,000 m. this question will look to estimate the pressure at this depth in the ocean. (a) (2 points) assuming that the salt water in the ocean has a constant density of 1030 kg/m", compute the pressure at this deepest point in the ocean. use gage (relative) pressure, with p= 0 pa at the surface. (b) (4 points) while liquids are approximately incompressible, at such depths density variations can be noticeable. assume that the density of the water varies with depth by the equation p- po ppo cape p= po exp where po and po are the density and pressure at the surface, and ey = 2.3 x 10° n/m² is the modulus of elasticity of water. using the differential form of the hydrostatic pressure equation dp da = -29, determine the pressure at the deepest point of the challenger deep. as- sume that po = 1030 kg/m². how does this compare to your answer for part (a)?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
You know the right answer?
The deepest part in the ocean is the challenger deep within the mariana trench, which has a maximum...
Questions
Questions on the website: 13722359