subject
Engineering, 13.09.2019 20:10 aidy3259

Two reversible power cycles are arranged in series. thefirst
cycle recieves energy by heat transfer from a hot reservoirat
temperature th, and rejects energy by heat transfer to areservoir
at an intermediate temperature t < th. thesecond cycle recieves
energy by heat transfer from the reservoir attemperature t and
rejects energy by heat transfer to a coldreservoir at temperature
tc < t.
a) obtain an expression for the thermal efficiency of a
singlereversible power cycle operating between hot and cold
reservoirs atth and tc, respectively, in terms of the thermal
efficiencies ofthe two cycles.
b) obtain an expression for the intermediate temperature t
interms of th and tc for the special case where the
thermalefficiencies are equal.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
You know the right answer?
Two reversible power cycles are arranged in series. thefirst
cycle recieves energy by heat tra...
Questions
Questions on the website: 13722367