Engineering, 13.09.2019 23:30 cheesedoodle

An engineer machines annealed copper in an orthogonal machining experiment. given: cutting speed: 4m/min(13.1 ft/min) depth of cut: 1.17 mm (0.046 in) machine efficiency; 98% width of cut 6 mm (0.236 in) tool material: aluminum oxide coated carbide tool geometry: 2degree relief angle. -5degree rake angle, 5degree clearance angle. 1.75mm (0.069 in) nose radius cutting fluid: synthetic oil (coefficient of friction -0.1) use us standard units for all your work. calculate the shear angle when machining with synthetic oil. calculate the required horse power for the machine engine (motor).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

An engineer machines annealed copper in an orthogonal machining experiment. given: cutting speed:...

Questions