Engineering, 14.09.2019 00:10 powerprefection4114
A30mm square tubing is to be welded to a steel frame and is loaded by a tension of 2kn and a bending moment of 300nm. the weld material is e7020 and the steel tube is aisi-1050 hr. determine the minimum thickness of the tube material for a factor of safety of 2. note this is not the weld. determine the minimum size weld assuming that the tube is welded all around.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
You know the right answer?
A30mm square tubing is to be welded to a steel frame and is loaded by a tension of 2kn and a bending...
Questions
Mathematics, 08.12.2021 21:30
Law, 08.12.2021 21:30
SAT, 08.12.2021 21:30
Mathematics, 08.12.2021 21:30
Mathematics, 08.12.2021 21:30
History, 08.12.2021 21:30
Advanced Placement (AP), 08.12.2021 21:30
History, 08.12.2021 21:30
English, 08.12.2021 21:30
Chemistry, 08.12.2021 21:30
Chemistry, 08.12.2021 21:30
Mathematics, 08.12.2021 21:30
SAT, 08.12.2021 21:30
