Engineering, 14.09.2019 01:30 electrofy456
Prove mathematically with a diagram of surfaces in contact that the coefficient of friction is a material's/manufacturing property independent of the areas of surfaces in contact.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
Prove mathematically with a diagram of surfaces in contact that the coefficient of friction is a mat...
Questions
Mathematics, 18.03.2022 16:10
Mathematics, 18.03.2022 16:10
Computers and Technology, 18.03.2022 16:10
Mathematics, 18.03.2022 16:10
Spanish, 18.03.2022 16:10
Mathematics, 18.03.2022 16:10
Social Studies, 18.03.2022 16:10
