Engineering, 14.09.2019 04:10 rrojassaucedo
What are two advantages of forging when compared to machining a part from a billet?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:10
Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates
Answers: 3
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
You know the right answer?
What are two advantages of forging when compared to machining a part from a billet?...
Questions
Mathematics, 04.02.2021 01:10
Business, 04.02.2021 01:10
English, 04.02.2021 01:10
Chemistry, 04.02.2021 01:10
Mathematics, 04.02.2021 01:10
Mathematics, 04.02.2021 01:10
Mathematics, 04.02.2021 01:10
Mathematics, 04.02.2021 01:10
Computers and Technology, 04.02.2021 01:10
Mathematics, 04.02.2021 01:10
