subject
Engineering, 14.09.2019 04:30 Emilyvite6251

Aconverging elbow turns water through an angle of 135* in
avertical plane. the flow cross-sectional diameter is 400mm atthe
elbow inlet, section (1), and 200mm at the elbow outlet, section
(2). the elbow flow passage volume is0.2m3 between
sections (1) and (2). the watervolume flow rate is
0.4m3/s, and the elbow inlet andoutlet pressures are 150
and 90kpa. the elbow mass is12kg. calculate the horizontal (x
direction) and vertical (zdirection) anchoring forces required to
hold the elbow inplace.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
question
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
Aconverging elbow turns water through an angle of 135* in
avertical plane. the flow cross-sect...
Questions
question
English, 19.05.2020 14:16
question
Mathematics, 19.05.2020 14:16
Questions on the website: 13722359