Engineering, 14.09.2019 05:30 tyneshiajones124

Heat transfer in an iron: consider the base plate of a 1200- w household iron that has a thickness of l = 0.5 cm, base area of a = 300 cm2 , and thermal conductivity of k = 15w/m–k. the inner surface of the base plate is subjected to uniform heat flux generated by the resistance heaters inside, and the outer surface is exposed to ambient air and large surroundings at t_infinity = t_surface. the areas of both the inner and outer surfaces are a_s = 0.040 m2. an approximately uniform heat flux of q'' = 1.25x10^4 w/m2 is applied to the inner surface of the base plate, and the convection coefficient at the outer surface is h = 10 w/m2*k.(a) sketch the system and simplify the energy balance equation for the base plate, taking radiative effects into account.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

You know the right answer?

Heat transfer in an iron: consider the base plate of a 1200- w household iron that has a thickness...

Questions