Engineering, 14.09.2019 05:30 bee1538

Acompressor requiring 89.5 kw, is to run at about 250 rpm. the drive is by v-belts from an electric motor running at 750 rpm. the diameter of the pulley on the compressor shaft must not be greater than 1 m while the centre distance between the pulleys is limited to 1.75 m. the belt speed should not exceed 1600 m/min. determine the number of v-belts required to transmit the power if each belt has a cross sectional area of 3.75 cm' and weighs 0.00981 n/cm and has an allowable tensile stress of 245.2 n/cm. the groove angle of the pulley is 35'. the co-efficient of friction between the belt and the pulley is 0.25. calculate also the length required of each belt.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Acompressor requiring 89.5 kw, is to run at about 250 rpm. the drive is by v-belts from an electric...

Questions