Engineering, 14.09.2019 23:10 doggo910

An enerpac rar204 hydraulic jack is to be used to lift a large object with a mass of 33,500kg. the object needs to be lifted 7.5cm. the jack has a maximum stroke of 10cm. in order to position the jack, oak 4x4 cribbing is used. will this set up work if the hydraulic pump has a capacity of 69 mpa? given oak's e=8.9gpa and σcomp=50mpa
(points? idk let me know if it should cost more points)

An enerpac rar204 hydraulic jack is to be used to lift a large object with a mass of 33,500kg. the o

Answers: 3

Show answers

Another question on Engineering

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

Engineering, 06.07.2019 02:30

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

Answer

Engineering, 06.07.2019 04:30

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volume for a gas is much higher than the average volume for a liquid. d)-there is no difference.

Answers: 2

Answer

You know the right answer?

An enerpac rar204 hydraulic jack is to be used to lift a large object with a mass of 33,500kg. the o...

Questions