Engineering, 01.10.2019 05:00 roseemariehunter12

Ay-connected balanced three-phase source is feeding a balanced three-phase load. the voltage and current of the source coil are = 325 sin( + 0.393) [v] = 22.6 sin( + 0.785) [a] calculate the following: a) the rms phase voltage. b) the rms line-to-line voltage. c) the rms current in the source. d) the rms current in the transmission line. e) the frequency of the supply. f) the power factor at the source side, state leading or lagging. g) the three-phase real power delivered to the load. h) the three-phase reactive power delivered to the load. i) if the load is connected in delta configuration, calculate the load impedance. j) in what regions of the world is this a typical residential voltage?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

Ay-connected balanced three-phase source is feeding a balanced three-phase load. the voltage and cur...

Questions