Engineering, 01.10.2019 23:10 Seventhhokage465

Camp stove is used to heat and boil water. a full tank of fuel can provide a heat transfer of 1.50 mj to the water on the stove. assume the atmospheric pressure is 1 bar and the specific heat of liquid water is 4.18 kj/(kg-k). for a full tank of fuel, find: (a) the mass of liquid water, in kg, that can be heated from 10°c to the temperature (99.6 °c) at which water vapor will initially occur. assume the liquid water is incompressible with constant specific heat. (b) repeat (a) using property tables for water. (c) the mass of liquid water, in kg, that can be com

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

You know the right answer?

Camp stove is used to heat and boil water. a full tank of fuel can provide a heat transfer of 1.50 m...

Questions