Engineering, 05.10.2019 13:30 foriegnngal

Africtionless piston-cylinder with stops has an initial volume of 1.2 m^3 and contains 2.4 kg of water with an initial temperature of 100°c. at this state, the piston is partially supported by a set of stops. the mass of the piston is such that a pressure of 300 kpa is required to lift the piston off of the stops. the system is heated until the temperature is 250°c. a. determine the initial pressure of the water b. if the piston lifts off the stops during the process, find the temperature when the piston first begins to rise. if the piston doesn't lift off the stops, determine the final pressure. c. calculate the work for the process. d. calculate the heat transfer for the process. e. show the entire process on p-v and t-v diagrams.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

Africtionless piston-cylinder with stops has an initial volume of 1.2 m^3 and contains 2.4 kg of wat...

Questions