Engineering, 06.10.2019 01:00 jlopez113

Apower plant operates on a regenerative vapor power cycle with one open feedwater heater. steam enters the first turbine stage at 12 mpa, 560°c and expands to 1 mpa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 mpa. the remaining steam expands through the second turbine stage to the condenser pressure of 6 kpa. saturated liquid exits the open feedwater heater at 1 mpa. the net power output for the cycle is 330 mw. for isentropic processes in the turbines and pumps, determine(a) the cycle thermal efficiency.(b) the mass flow rate into the first turbine stage, in kg/s.(c) the rate of entropy production in the open feedwater heater, in kw/k.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

You know the right answer?

Apower plant operates on a regenerative vapor power cycle with one open feedwater heater. steam ente...

Questions