Engineering, 06.10.2019 04:00 mariaceleste110505

Acarnival ride is designed to allow the general public to experience high acceleration motion. the ride rotates about point o in a horizontal circle such that the rider has a speed v0. the rider reclines on a platform a which rides on rollers such that friction is negligible. a mechanical stop prevents the platform from rolling down the incline. the carnival ride is modified so that 80 kg riders can move up and down the inclined wall as the speed of the ride increases. know that the coefficient of static friction between the wall and the platform is 0.29. determine the range of values of the constant speed v0for which the platform will remain in the position shown. (round the minimum velocity, vmin to three decimal places and the maximum velocity, vmax to two decimal places.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

You know the right answer?

Acarnival ride is designed to allow the general public to experience high acceleration motion. the r...

Questions