Engineering, 05.10.2019 00:20 machapman6594

3. exhaust gas from a chemical process flows at a rate of 8000 acfm from point a at 250 degrees f and 1 atm pressure. it is flows through a circular duct to a fan where the pressure is boosted by 4 inches of water and then flows to an incinerator. fuel gas is burned at a rate of 75 pounds per hour and the temperature of the exhaust gas is 1200 degrees f. assuming both the process exhaust and incinerator exhaust streams have properties similar to air, calculate the enthalpy that has been added by burning the fuel gas. assume that you can recover heat from the incinerator exhaust by purchasing aheat exchanger to cool the gases to 500 degrees f while recovering the useful heat. assuming that such heat is worth $7/million btu, how much money could you save by recovering the heat ($/day)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

You know the right answer?

3. exhaust gas from a chemical process flows at a rate of 8000 acfm from point a at 250 degrees f an...

Questions