Engineering, 09.10.2019 00:00 elliebomb13

Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a what is the electric field strength inside the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part b what is potential difference across the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer part c what is the electric field strength inside the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part d what is the potential difference across the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer provide feedback next

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

You know the right answer?

Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a...

Questions