Engineering, 09.10.2019 01:30 valerrry

Arod of diameter d=25mm and thermal conductivity k=60w/(mk) protrudes normally from a furnace wall that is at tw=200°c and is covered by insulation of thickness lins=200mm. the rod is welded to the furnace wall and is used as a hanger to support instrumentation cables. to avoid damaging the cables, the temperature of the rod at its exposed surface, to, must be maintained below a specified operating limit of tmax=100°c. the ambient air temperature is 30°c, and the convection coefficient is 17.0 w/(m2k). a) derive an expression for the exposed surface temperature, to, as a function of the prescribed thermal and geometrical parameters. the rod has an exposed length lo, and the tip is well insulated. b) will a rod of length lo=180mm meet the specified operating limit? if not, which design parameters would you change? note the variables and whether increasing or decreasing them would change to.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

You know the right answer?

Arod of diameter d=25mm and thermal conductivity k=60w/(m*k) protrudes normally from a furnace wall...