Engineering, 10.10.2019 00:20 tybizz

The shark tank at an aquarium houses 5 sharks that deplete the aquarium water of a total of 60.00 g of oxygen per hour. water from the tank is diverted through a bubbler unit that oxygenates the water using a stream of oxygen-rich air, and then is returned to the tank. at steady state, water enters the bubbler containing 0.000700 wt% o2 and exits the bubbler containing 0.001000 wt% o2. for every kilogram of the inlet water stream that enters the bubbler, 0.00500 mol of oxygen-rich air with an initial composition of 25.00 mole% o2 and 75.00 mole% n2 is fed through the bubbler. draw and label a flowchart for the process described. perform a degree of freedom analysis (dof) of the process. what are the flow rates of water entering the tank? what is the composition (in wt %) of the outlet air leaving the tank?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

You know the right answer?

The shark tank at an aquarium houses 5 sharks that deplete the aquarium water of a total of 60.00 g...

Questions