Engineering, 11.10.2019 04:10 zoieihazel

You are interning at a power-plant engineering company that is in the process of designing a new steam cycle. your manager asks you to in estimating the turbine work output for 2 different operating conditions: (i) water enters the turbine at 600 °c and 17.5 mpa and exits at 20 kpa as a saturated mixture with a quality of 0.95. (ii) same inlet conditions as (i), but exits at 20 kpa as a saturated mixture with a quality of 0.85. (a) calculate the turbine work output per unit mass of water for conditions (i) and (ii). (b) comment on the difference in the turbine work output between conditions (i) and (ii). (c) show the process across the turbine for conditions (i) and (ii) on the same t–v diagram.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

You are interning at a power-plant engineering company that is in the process of designing a new ste...

Questions